Land Pride
Section 3: Adjustments
Table of Contents
Drive Chain
Refer to Figure
The tension on the drive chain can be easily adjusted by using the chain tightener stud.
Should excessive backlash occur, unscrew the lock nut, turn the bolt, Figure
25590 |
Rear Deflector
& Down Pressure Kit
The rear deflector can be adjusted closer to the ground to produce a fine soil texture or can be raised to produce a coarse soil texture by adjusting the spring rods. Adjust rear deflector to the desired height and install cotter pins in one of the top six holes on the spring rods above the cushion springs Figure
20549 |
Chain Tightener
Figure
Skid Shoe
Refer to Figure
The skid shoes can be raised or lowered for the desired tilling depth by:
1.Raise tiller off the ground and properly support.
2.Loosen pivot bolt on front of shoe.
3.Remove adjusting bolt on rear of shoe.
4.Adjust skid shoe to desired location.
5.Install adjusting bolt, and tighten both the adjusting bolt and the pivot bolt.
IMPORTANT: Be sure both skid shoes are adjusted the same.
Loosen |
20550 |
Skid Shoe Adjustment
Figure
Rear Deflector
Figure
The rear deflector can be raised and secured for replacement of spring tines by removing the cotter pins and raising the deflector enough to reinstall the cotter pins in hole no. 7 on the spring rods below the cushion springs.
An optional spring kit, part no.
NOTE: Too much pressure will cause premature wear on the rear deflector.
7/03/07 | RTA2064, RTA2072, RTR2064 & RTR2072 Rotary Tillers | 13 |