Table of Contents
Section 4: Maintenance and Lubrication
Land Pride
Clutches With 8 Hex Socket Bolts
Clutch
Refer to Figure
1.Loosen counterclockwise all 8 hex head socket bolts uniformly 6 full turns.
2.Cycle clutch on and off 5 or 6 times (15 seconds on and 15 seconds off) with the engine operating at half throttle. Disengage driveline, shut off tractor and remove key. Wait for all components to stop before dismounting from tractor.
3.Tighten hex head socket bolts fully back. Clutch is ready for use
4.The clutch should be checked during the first hour of cutting and periodically each week.
Hex Head
Socket Bolts
21270
Clutch
Figure
Clutch Disassembly & Assembly
Refer to Figure
If clutch
1.Rotate 8 Alan head socket bolts (#2) all the way out to free stop flange (#3).
2.Record position of the lips (up or down) on stop flange (#3) and then rotate flange and remove it.
3.Remove the following inner components:
a.Spring kit (#4)
b.Pressure flange (#5)
c.1st Friction Disc (#6)
d.Hub with flange and pull collar (#7 & #1)
e.2nd Friction disc (#6)
f.Intermediary flange (#8)
g.3rd Friction disc (#6)
h.Hub disc (#9)
i.4th Friction disc (#6)
j.Bearing (#10)
4.Inspect all components and replace to their original position. Make certain stop flange (#3) is replaced with its flanges down as shown.
5.Fully tighten all 8 Alan head socket bolts (#2).
(IMPORTANT NOTICE) Check position of lip on stop flange (UP or DOWN). Replace stop flange with lip in its original position.
21303
Clutch Assembly
Figure
16 RTA2064, RTA2072, RTR2064 & RTR2072 Rotary Tillers | 7/03/07 |