Land Pride | Table of Contents |
Section 1: Assembly and Set-Up
Tractor Requirements
This tiller is designed with a
NOTE: In order to maintain steering control, ballast may have to be added to your tractor. To determine whether or not to add ballast, refer to your tractor operator’s manual.
!CAUTION
Do not over speed PTO or machine damage may result. This tiller is designed to be used with a tractor using a 540 RPM rear PTO.
3-Point Hitch & Shaft Cover Assem- bly
Refer to Figure 1-1:
1.Install right hand and left hand top hitch halves (#3) and (#4) to the inside of the hitch mounting bars bolted on the frame with 5/8” bolts (#11), nuts (#14) and lock washers (#18). Do not tighten bolts at this time.
2.Insert the top hitch spacer tube (#1) between the left hand and right hand hitch as shown and secure with the 3/4” bolt (#12), nut (#15) and lock washer (#19).
3.Tighten all bolts to recommended torques. See “Torque Values Chart” on page 23.
Driveline Guard Assembly
1.Assemble clamp (#5) to the plate (#8) with one of the wing bolts (#9).
2.Assemble the driveline guard (#6) to the top hitch with the four other wing bolts (#9).
3.Install cover (#7) to tiller with wing bolts (#9).
4.Fasten plate (#8) to the driveline guard (#6) with the 5/16” bolt (#10), flat washer (#17), lockwasher (#16) and nut (#13). The clamp (#5) should catch the lip of cover (#7).
Parking Stand Assembly
Refer to Figure
Install the parking stand (#2) through the stand bracket and adjust stand to desired height and pin with 5/16” wire lock pin (#20).
7/03/07 | RTA2064, RTA2072, RTR2064 & RTR2072 Rotary Tillers | 7 |
