Lowrance electronic 100 installation instructions

6.Install and tighten four M10 x 25U (M10 x 1") mounting bolts. Use anti-corrosive grease on each bolt to avoid difficulty in removing the bolts later on.

7.Uncoil the scanner cable.

8.Secure the cable near the scanner to support the weight of the cable and prevent strain on the watertight cable seal. If the cable is to pass through tubing or a bulkhead, protect the unfinished end. Do not use the unfinished wires or fabric braid to pull the cable. Attach a fish cord only to the cable jacket.

Route the cable to the RIM 100 module’s location, securing it at appro- priate points along the way. Make a drip loop and apply sealant at the entry point of an exterior bulkhead.

9