8
the Tank Size window. (If you choose a single-tank configuration, you
will not have to choose the tank. You will be directed to the Tank Size
window covered in Step 4.)
4. Use the UP and DOWN keys to input the number of gallons the tank
will hold and press MENU. Repeat steps 3 and 4 for each additional
tank. After all tanks have been set up, you will be directed to the main
display.
Boat Setup Reset
If you want to access the Setup screen (Boat Setup) after an engine-
tank configuration has been chosen you will have to reset the
configuration to default settings.
To reset engine tank configuration:
1. Press MENU, highlight SYSTEM SETUP and press MENU.
2. Choose ENG/TANK and press MENU twice. The following message will
appear: Hit menu to reset Eng/Tnk.
3. Press MENU. The Setup screen will appear with Boat Setup
highlighted.
EP-80R Temp Configuration The EP-80R Temperature sensor has three configuration options:
Inside, Outside and Water. An unconfigured temperature sensor will
appear on the Bus Devices list as UnCfg Temp.
To configure a temp sensor:
1. Press MENU, use the UP and DOWN keys to select SYSTEM SETUP and
press MENU.
2. Highlight B. DEVICES and press MENU. After a few moments the Bus
Devices list will appear.
3. Highlight UNCFG TEMP and press MENU. The following message will
appear: Hit Menu to Cfg Temp Sns.
4. Press MENU to be taken to the Selecting Temp menu, which will have
three options: Inside, Outside and Water.
5. Highlight the desired temp option and press MENU. The temp sensor
has now has been configured. You will be directed to the Bus Devices
list.
NOTE:
If your temp sensor is not updated on the Bus Devices list, refresh
the list by letting it time out and then access it again.