If LED blinks ON/OFF three times during the power-up cycle and then turns OFF, an Ethernet loop back connector should be connected to the IM Network Cable and the LWX-1 should be power cycled. If the blinking during power-up does not recur, then the IM Network Cable is good, and the end-user device should be checked.
When IM Network Cable is properly connected to the host device, the end-user can request a full LWX-1 Diagnostics Report to perform any further required diagnosis. The following section describes the information provided in this diagnostic report.
The SIRIUS satellite service activation process will require the SIRIUS ID for the SIRIUS Radio Module is visible to the user. This will allow the SIRIUS Listener Care call center to activate the user’s subscription for the LWX-1. Signal Strength will also be important information for the user to verify that SIRIUS radio signal is available as this is required for successful activation.
LWX-1 SIRIUS Activation
You must have a SIRIUS subscription to use the LWX-1 module. Individual weather and audio subscriptions are available. You can also purchase a subscription that includes both weather and audio.
Before calling SIRIUS to activate a subscription for your LWX-1 make sure the following conditions are met:
•The LWX-1 and your display unit are turned on and connnected via ethernet cable
•SIRIUS status info — antenna status and signal strength — is shown on your display unit screen (refer to your unit’s operation manual to access the SIRIUS status screen)
•SIRIUS status screen shows signal strength of at least 1/3 with 2/3 or greater preferred
•Have the ESN — electronic serial number — for the LWX-1 readily available (ESN, a 12-digit number, can be found on the LWX-1 carton, LWX-1 antenna or via the SIRIUS status screen)
•Credit card/billing information is available
