Lowrance electronic LWX-1 installation instructions AR Flush Mount Installation above deck

3.Drill the 1/32 inch diameter starter holes for the AR Mounting Screws and the 1/2 inch diameter hole to route the AR Interconnect Cable through the deck. Make sure the gasket is sealed tightly against the deck

4.Insert AR Interconnect Cable through the deck and pull it through

5.Using the four AR Mounting Screws provided, mount the AR to the deck

6.Insert AR Screw Caps into AR Bolt recesses on the AR Cover.

3.AR Flush Mount Installation (above deck)

In this AR Flush Mount installation, the cable is routed out the back of the LWX-1.

This installation is the same as AR Flush Mount through- deck Installation, except the AR Interconnect Cable is routed under the LWX-1 and out the back above the deck instead of through the deck.

To use AR Flush Mount above-deck installation:

1.With a pair of needle-nose pliers, break away and remove the AR Channel Stop

2.Insert the AR Interconnect Cable into cable channel on bottom of

LWX-1

3.Ensure that the rubber boot on the AR Interconnect Cable is firmly in the AR Rubber Boot Inset so that it is flush with the bottom of the AR Base.

5