holes in the bracket with the letter "B" aligned with the dot stamped in the bracket.

Reassemble the transducer and bracket and place them against the transom. Again, check to see if you can move the transducer so it's parallel with the ground. If you can, then go to step 3. If it doesn't, repeat step 2, but use a different alignment letter until you can place the transducer on the transom correctly.

Ratchets

Insert bolt and check transducer position on transom.

3.Assembling the transducer. Once you determine the correct posi- tion for the ratchets, assemble the transducer as shown in the fol-

lowing figure. Don't tighten the lock nut at this time.

Metal

Nut washer

Rubber

Metal washer

washers

 

Bolt

Assemble transducer and bracket.

4.Drilling mounting holes. Hold the transducer and bracket assembly against the transom. The transducer should be roughly parallel to the ground. The transducer's centerline should be in line with the bottom of the hull. Don't let the bracket extend below the hull!

Mark the center of each slot for the mounting screw pilot holes. You will drill one hole in the center of each slot.

Drill the holes using the #29 bit (for the #10 screws).

9

Page 13
Image 13
Lowrance electronic X67C manual Ratchets, Metal Nut washer Rubber, Washers, Bolt