1.3.1 Internal SCSI Bus Connections
This section provides step-by-step instructions about making internal SCSI bus connections.
Step 1. To connect an internal SCSI device, plug the 50-pin connector on one end of the SCSI ribbon cable into the connector J2 (see Figure 1.3). The ribbon cable included in your LSI20860 kit is keyed to ensure it is connected correctly.
Step 2. Plug the 50-pin connector on the other end of the SCSI ribbon cable into the SCSI connector on your internal SCSI device.
Step 3. To attach more than one internal device, use an internal SCSI ribbon cable with the required number of 50-pin connectors attached along its length. Plug the cable connectors into the internal SCSI device connectors, as illustrated in Figure 1.3.
Step 4. Terminate the SCSI bus as described in the Section 1.3.3, “SCSI Bus Termination,” page 1-10.
Step 5. Make any required power connections to your internal SCSI device(s).
