Note: Notice that the components on a PCI host adapter face the opposite way from non-PCI adapter boards you have in your system. This is correct, and the board is keyed to go in only one way.

Step 7. The bracket around the external connector J3 should fit where the blank panel was removed. Secure it with the bracket screw before making the internal and external SCSI bus connections. See Figure 1.2.

Step 8. To connect any internal SCSI device, plug a 50-pin connector on the end of the internal SCSI ribbon cable into the J2 connector.

Step 9. Make sure the connection to the opposite end of the ribbon cable has been made to a SCSI device. See Figure 1.3.

Step 10. Replace the cabinet cover as described in the user’s manual for your computer.

Step 11. Make all external SCSI bus connections. Finally, refer to the PCI Storage Device Management System SDMS 4.0 User’s Guide (or the guide for the software that you will use) to load the driver software for your particular operating system.

1-6

Using the LSI20860

Page 14
Image 14
LSI manual Using the LSI20860