2.2.3.1 Making Internal SCSI Bus Connections

This section provides step-by-step instructions about making internal SCSI bus connections. If you have no internal devices to connect, proceed to Step 4.

Step 1. Plug one end of a SCSI ribbon cable into an appropriate connector, J2, J4, or J5. The example in Figure 2.4 shows a wide cable.

Channel A (J2 and J4) supports SE mode. Channel B (J5) supports SE and LVD modes.

Figure 2.4 Internal SCSI Ribbon Cable to Host Adapter

J5

J2

J4

J3

2-8

Installing the LSI21003