LSI DF1153-E1 manual Drive Module Cable Requirements, E3300 Interface Cables, SCSI Terminators

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Drive Module Cable Requirements

Drive Module Cable Requirements

E3300 Interface Cables

The E3300 drive module has two SCSI connectors. To connect the drive module to a SYM1000E command module, you must use 68-pin, VHDCI (very high density cable interface) LVD, Ultra SCSI-2 cables.

The maximum length for any SCSI, 68-pin HD cable is 25 m (82 ft.) or 12 m (39 ft.) for VHDCI cable. The total length includes both internal and external cabling. The SCSI cabling inside this drive module is approximately 0.1 m (4 in.) for the host bus. Table 14 lists the SCSI cables that you can use on this drive module.

Table 14 SCSI Drive Interface Cables

	Order Information
Cable Description
	Part	Length
	Number
	006-1086595	1.0 meter
	006-1086596	1.5 meter
LVD, Ultra SCSI-2 cable with 68-pin, VHDCI connector
	006-1086597	3.0 meter
	006-1086598	8 meter

SCSI Terminators

If you are installing the drive module as the last device on a SCSI bus, you must install a 16- bit terminator on the OUT connector. Every drive module shipped from the factory includes 16-bit terminators.

Drive Module Site Preparation Guide 27