x 4 T I M E

x 4 P R O G R A M M I N G

 

 

Programming the X4

Programming the switch on /

 

switch off function (P1,P2,P3)

The X4 allows the following functions to be

 

programmed:

This function allows you to program three

Clock time

active periods for the machine throughout the

Sleep/active modes

day (P1, P2 and P3). On the display, you will

Temperature at which coffee is prepared

see “L’ORA” (TIME).

Duration of coffee preparation

 

Programming the clock time

 

Depress the temperature button (2) for approximately 3 seconds. The time display will flash.

To program P1, proceed as follows:

Press button (2) for approximately 3 seconds. Next, press the same button two more times. P1 will now be displayed.

Use buttons (3) and (4), to set the hours. Press button (2) again to set the minutes. You have now set the clock time.

Press button (2), (or after a few seconds) this time wil be displayed.

3 sec. 3 sec.

Now press button (3) or (4): the clock time for the ACTIVE function will appear and flash.

+ -

Press buttons (3) and (4) to set the hours.

+ -

+ -

If the time is shown on the display, the X4 is in sleep mode. This means that the machine is in an energy-saving mode while retaining full programmed functionality. If you want to use the machine while it is in SLEEP mode, just press button (2), the temperature will be displayed and the machine will be in ACTIVE mode. When the cup stops blinking, you will be able to prepare an espresso.

NB: Unplugging the machine, or using the on/off button (1) to turn it off will result in the loss of any machine setting you have programmed after about 8 hours. When the machine is turned on again , the machine will revert to the factory “default” settings.

Press button (2) once again to set the minutes. Now, press button (2) a further time, to change the clock time for the sleep function.

+ -

Set the clock time as described above. Now, wait a few seconds or press button (3). The display will revert to showing the current clock time and also show the word ‘PROGRAM’. (This means that at least one of the three programs is active).

26

27

Page 5
Image 5
Luca Trazzi X4 I M E R O G R a M M I N G, Programming the clock time, Sec sec, Press buttons 3 and 4 to set the hours