7.After bed ends have been attached, install bed end safety pins to act as safety latches.

(Bed End Safety Pin Kit part number: 690-1000-100; includes four clevis pins, four hitch pins and four washers). A lan- yard is supplied to attach hardware to the bed or the end upon disassembly.

Insert pins and washer as shown at right, with flat washer on outside of bed end hook. Bed end safety pins, while not necessary for normal bed operation, will prevent the bed ends from accidentally rolling off when moving or pushing the bed, or while installing or using bed-mount trapezes.

washer

bed end hook

Install bed end safety pins

Full-electric bed only (US0458/US0458PL): Align motor and gearbox

After installing foot end, you may have to shift bed frame slightly in bed end hooks to ensure proper horizontal alignment with motor coupling and end gearbox shaft.

When coupling and shaft are aligned, unlock spring-loaded coupling. Coupling may not snap into groove until motor is rotated with pendant hand control after bed is assembled.

HEAD

FOOT

Route cord under cross-angle

Plug hi/lo motor into Okimat actuator assembly, being careful to route cord under the fixed base frame cross-angle as shown above to ensure clearance with hi/lo drive shaft. The motor plug is located next to the pendant hand control plug on the actuator.

All models: Assemble head bed end

8. Repeat steps 1-7 for head bed end.

US0208-INS-LAB-RevB09 • PatriotHomecare Bed

9

Page 9
Image 9
Lumex Syatems US0208 user manual All models Assemble head bed end