●One period ends at the start time of the next period. The end of one period may not be any closer to the beginning of the next period than one
time results in the latter time being pushed ahead too. Press NEXT to accept the displayed start time and advance to the SET TEMPERATURE, it will flash to show that it may be edited.
●The SET TEMPERATURE will be displayed on the right side of the display with the HEAT or COOL indica- tor visible (depending on which mode you have it in)
●Edit the SET TEMPERATURE, then press NEXT to accept and advance to the next period.
●When all the periods for the weekdays have been set, the start time for the next weekday Morning period will be displayed to begin editing the settings for that day.
●Complete programming for all weekdays and rotate the dial back to RUN to accept all current values and end the programming session.
WEEKEND PROGRAMMING
Weekend programming is identical to weekday pro-
gramming except that you must rotate the dial to SET WEEKEND PROGRAMS and the days that you will
program are Sa and Su together. This two day program will repeat.
ADVANCED FEATURES
CALIBRATION OFFSET
Your thermostat is accurately calibrated at the factory to within + 1°F. An offset value up to +5°F may be added to the temperature value that the thermostat measures. This may allow you to match this thermostat to another.
To change this offset from its default value of 0:
1.Open the door on the front of the thermostat.
2.Rotate the dial to SET DAY/TIME.
3.Simultaneously press NEXT and HOLD. The Temperature Offset value will flash.
4. The default value is 0 and in most cases should remain untouched.
5.Use the UP/DOWN keys to adjust the offset value.
6.Return the dial to its RUN position to accept the new value.
SOFTWARE RESET
Use this feature to make all settings and programs return to their default values. Press and release [RESET] button using a pen or pencil. It will perform a system check and then returns all settings to their original default values before initiating normal operation.
NOTE: Pressing this button will overwrite your program and install the default values of all temperature programs and setup values into the unit's nonvolatile memory. To ease reprogram- ming later, record your thermostat's programs and settings in the table provided at the page bottom before using this button.
TEMPERATURE VARIATION / SWING
Your thermostat works by turning your heating or cooling system on and off whenever the room temper- ature varies a certain number of degrees from the set- point temperature. This variation is the "swing". Your system should cycle on about 3 to 6 times per hour. A smaller swing number increases the number of cycles, so room temperature is more constant. A larger swing number decreases the number of cycles, saving ener- gy in most cases.
SWING ADJUSTMENT
This setting controls when the heating or cooling turns on and off.
●The Swing setting sets the temperature variation the system allows above or below the set temperature before turning on the heating or Cooling. To change
this value:
1.Rotate the SPEED DIAL® to RUN.
2.Press NEXT and HOLD simultaneously. The Temperature section of the display shows a single digit number between 1 and 9.
