Lyngdorf Audio W-210 Connecting, Set-up of cut-off frequency, Level, Cleaning, Specifications

Connecting

When connecting the W210s, always connect ”+” and ”-” from the amplifier to the corresponding ”+” and ”-” terminals on the W210 input.

Connect your speakers the same way to avoid phase errors.

Set-up of cut-off frequency

To match most speakers bass response, we recommend a cut-off frequency at 400Hz. But depending on you speakers and room, the cut-off frequency can easily vary from 200-800Hz. Try experimenting to get the best sound.

Level

Adjust the level of the W210s to match the sound level of your main speakers.

If applying RoomPerfect you can set the volume of the W210s a few dB to loud before making the RoomPerfect calibration. RoomPerfect will then lower the bass to an appropriate level.

Cleaning

Please use a dust-free cloth to clean the speakers. It is also possible to use a slightly damp cloth for more stubborn marks.

Under no circumstances should you use any kind of cleaning agent on, or in close proximity to, these speakers.

Specifications

Product	W210
Woofer/midrange driver	2 x 10”
Frequency response	16 - 3500 Hz
Sensitivity (2.83V/1m)	96dB
Nominal Impedance	8 Ohm

3