M&S Systems DMC3-4 installation instructions Replacing the Room Stations, Transformer placement

Figure 5 - dmc3-4HC transformer connection

T E 5 C

T E 2 C

dmc3-4

For the dmc1HC combo wall housing have a qualified electrician loop a power wire from the TE5C transformer enclosure to the TE2C transformer enclosure following the same

procedure described above and shown in

Figure 5.

Figure 4 – Transformer placement

Replacing the Room

Stations

The DMC room and door speakers use the existing wire and speaker rough-in mounting frames or boxes. To replace the speaker, first remove the old speaker. Leave the existing room or door station mounting rings in place.

After removing the room station verify the integrity of the wire run. Then install the mounting plate from the DMCFR (finish-out frame for room stations). Align the plate on the wall either vertically or horizontally so that the screw holes line up with those on the mounting ring or box. Use a

level to make sure the plate is level. There are several screw hole locations on the mounting plate so it can attach to many rough-in designs. Mount the plate to the wall using the screws provided (Figure 6).

Figure 6 - DMCFR installation

www.mssystems.com 800.421.1587

Page 11