![](/images/new-backgrounds/1016238/162383x1.webp)
INSTALLATION FOR EXISTING CONSTRUCTION OR TRIM OUT OF NEW CONSTRUCTION:
Step 1 Determine speaker location and mark your plans for future | Step 3 Remove grill cover from speaker. Use four screws provided to |
reference. These speakers DO NOT use mounting rings. Cut | fasten speaker to the opening in ceiling. Install the speaker in |
a 9 3/8" diameter hole in the ceiling for the speaker. Each | the ceiling opening, as shown in figure 2. Turn the mounting |
speaker should be mounted at least 2' from the walls if ceiling | clamp screws clockwise until the speaker is secure. DO NOT |
mounted or at least 2' from the ceiling if wall mounted. | OVER TIGHTEN the screws. This can damage the speaker |
DO NOT mount speakers in outside walls. | and/or the ceiling material and make the metal grill difficult |
| to install. |
Plastic clamping ears shown in | Step 4 Divide each adhesive bead strip in half. (Adhesive bead strips |
the install position (4 places) | are in clear plastic self closing bag). Place strips on edge of |
| |
| grill as shown in figure 2. Reinstall grill on speaker. |
Black (Violet) wire
FIGURE 1
Red (Blue) wire
Connect to
16 Gauge 2 conductor
wire from wall plate
or volume control
NR8M Speaker
Mounting Screws
Step 2 Remove the red & black wire pigtail (some speakers may be supplied with wires soldered to the terminals which should not be removed) from the speaker terminals and connect to the red & black (or Blue & Violet) wires from the speaker wire using wire nuts. Be sure that the red(blue) wire (+) is connect- ed to the red(blue) (+)pigtail lead and that the black(violet) wire
Metal Grill
Adhesive Bead Strip
4 Places
FIGURE 2
Ceiling Material
M&S SYSTEMS
115811 D