The subwoofer for the
RMS Power Rating | 100 Watts |
|
|
Frequency Response | 40 Hz to 350 Hz |
| |
Crossover | 40 Hz to 180Hz (Adjustable) | ||
Controls | Power, | Volume, | Crossover |
| Frequency, Phase |
| |
Connections | RCA Jacks and Spring Terminals | ||
Height | 13.3 “ |
|
|
Width | 9.8 “ |
|
|
Depth | 13.7 “ |
|
|
Weight | 20 lbs. |
|
|
UNPACKING YOUR SPEAKERS
After carefully unpacking your speakers, the carton and the packing material should be saved for possible use later. If any speaker appears to be damaged, do not attempt to repair or to connect the unit to the amplifier. Repack the speaker and notify your distributor or M&S Systems for replacement or repair.
SPEAKER PLACEMENT
The cube units can be mounted on the ceiling or walls of the room, therefore, many combinations are possible. The MNC or the front and rear cube speakers of the MNCS package should be separated by 6 to 8 feet for good stereo separation. They should not be any closer than 2 feet to any adjacent surface (wall or ceiling). The cube brackets should be attached to a stud or mounted anchor with bolts to provide secure mounting.
NEVER MOUNT THE BRACKETS TO SHEETROCK WITHOUT SOME TYPE OF ANCHOR. The placement of the center channel and the subwoofer (MNCS system only) are not as critical. The center channel is best located on top of the TV cabinet or on a shelf above the TV. The subwoofer should be placed near a corner at the front or rear of the room for best bass sound.
The MNC unit is designed with a swivel joint between the two speakers. Each speaker can be aimed individually. The unit also comes with a mounting bracket for attachment to a wall or ceiling. The bracket screws into the threaded socket on the bottom of the unit, and may be adjusted so that the speakers point in the desired direction. (See figure 1)
Note: When mounting speakers from wall surfaces additional tightening of the hex screw may be required.
2 of 7