Using an Aux Send with a Plug-in

Click the associated Input Source button and select an Aux input source. In the example below, we have chosen the Aux 4 Bus.

Send the Input Signal to the Aux Bus

1.Send a signal to a D8B mixer input channel (MIC/LINE or TAPE IN).

2.Assign the input channel V-Pot/GUI Control Pot to an aux send. We have chosen AUX 4 according to the example above.

3. Use the AUX 4 control to adjust the input level to the plug-in.

GUI Control Pot Assigned to AUX 4

Remember: Select an aux send before using the V-pot or GUI Control Pot on the mixer input channel (MIC/LINE or TAPE IN).

You will see the plug-in’s input meter become active as you raise the mixer input channel’s aux send.

Set the plug-in input/output signal levels as you would with any effect, so the meter reaches its upper-most range every so often (always trust your ears first). This can be accomplished from the console or GUI.

User’s Guide