vDo not perform any action that causes hazard to the customer, or that makes the equipment unsafe.
vBefore you start the machine, ensure that other service representatives and the customer’s personnel are not in a hazardous position.
vPlace removed covers and other parts in a safe place, away from all personnel, while you are servicing the machine.
vKeep your tool case away from walk areas so that other people will not trip over it.
vDo not wear loose clothing that can be trapped in the moving parts of a machine. Ensure that your sleeves are fastened or rolled up above your elbows. If your hair is long, fasten it.
vInsert the ends of your necktie or scarf inside clothing or fasten it with a nonconductive clip, approximately 8 centimeters (3 inches) from the end.
vDo not wear jewelry, chains,
Attention: Metal objects are good electrical conductors.
vWear safety glasses when you are: hammering, drilling soldering, cutting wire, attaching springs, using solvents, or working in any other conditions that might be hazardous to your eyes.
vAfter service, reinstall all safety shields, guards, labels, and ground wires. Replace any safety device that is worn or defective.
vReinstall all covers correctly before returning the machine to the customer.
Electrical Safety
Observe the following rules when working on electrical equipment.
Important
Use only approved tools and test equipment. Some hand tools have handles covered with a soft material that does not insulate you when working with live electrical currents. Many customers have, near their equipment, rubber floor mats that contain small conductive fibers to decrease electrostatic discharges. Do not use this type of mat to protect yourself from electrical shock.
vFind the room emergency
