Madrigal Imaging BPA 3, BPA 2 manual Rear Panel, 1AC MAINS RECEPTACLE, 2REMOTE TURN-ONJACK

Caution!

Warning!

Rear Panel

Turn the volume on your preamplifier all the way down before attempting to connect anything to your Proceed BPA 2 or BPA 3.

1AC MAINS RECEPTACLE

Connect the AC power cord (included in the accessory pack) to the I.E.C.- standard AC receptacle on the rear panel of the BPA, then to the AC mains outlet.

The Proceed BPA has been safety-tested and is designed for operation with a three-conductor power cord. Do not defeat the “third pin” or earth ground of the AC power cord.

2REMOTE TURN-ON JACK

A 1⁄8" “mini” jack above the AC mains receptacle on the rear panel allows remote-controlled turn-on (that is, toggling between on and standby) of the Proceed BPA. This remote “trigger” will be operated by 3–12 volts DC level signal, with tip polarity as shown below:

13