1 |
|
| 2 |
| 3 | 4 | 5 | 6 |
display |
|
|
|
|
|
|
|
|
intensity |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| inverted |
|
|
|
|
|
|
| mode | polarity |
|
|
|
|
|
|
|
|
| |
|
| monitor |
| record select |
| balance |
| PREAMPLIFIER Nº 380S |
|
|
|
|
|
| |||
mono | 1 | 2 | 3 | 4 | 5 | 6 | mute | standby |
|
7 | 8 | 9 | 10 |
Front Panel
1DISPLAY INTENSITY BUTTON
Cycles among four levels of brightness (including “off”) for the display, al- lowing adjustment for various ambient lighting conditions. When “off,” the display will turn on for a few seconds whenever a setting is changed. When used in conjunction with certain compatible Mark Levinson components, this button will control the display intensity of all linked components. (For more information, see “Linked Functions.”)
2ALPHANUMERIC DISPLAY
Provides a wide range of information concerning the operational status of the Nº380S. The information displayed depends on the operating mode the Nº380S is in (determined by the mode button). The information displayed is summarized below:
monitor | Selected (audible) Source and Volume |
record Select | “RECD” and Source to be recorded |
balance | Direction and Magnitude of Offset |
In addition, when used with Mark Levinson power amplifiers that incorpo- rate our communications link circuitry, this display is used to indicate the presence of a fault condition (if any) in the amplifier. Please refer to the owner’s manual of your amplifier for more information. For more detailed information on the preamplifier’s use of this display, see “Operational Modes.”
9
