Magic Chef MCWC45A Operating Your Appliance, Temperature Control, Changing The Inner Light

OPERATING YOUR APPLIANCE

Temperature Control

•Your wine cooler has one control for regulating the temperature. The temperature control is located on the top center of the wine cooler compartment.

•The first time you turn the unit on, adjust the temperature control knob to “7” and run for at least

2 hours before putting wine bottles inside. This will ensure the cabinet is thoroughly chilled before wine bottle is stored.

•The range of the wine cooler temperature control is from position "1" the warmest to "7" the coldest. Adjust the temperature control to the setting that best suits your needs.

-The setting of “2” is recommended for storage of red wines.

-The setting of “6” is recommended for storage of white wines.

•To turn off the wine cooler, please turn the temperature control knob to “0”. Please note that turning the temperature control knob to “0” position stops the cooling cycle, but does not disconnect the power supply to the wine cooler.

WARNING: Do not set the temperature control to setting of “7” position for longer than 8 hours.

If the unit is unplugged, loses power; you must wait 3 to 5 minutes before restarting the unit. If you attempt to restart before this time delay, the wine cooler will not start.

•Change in ambient temperature will affect the internal temperature of the wine cooler.

•If you choose to change the thermostat setting, adjust thermostat control by one increment at a time. Allow several hours for temperature to stabilize between adjustments.

Changing The Inner Light

Before removing the inner light, turn off the wine cooler first and then unplug the unit from the wall outlet. Failure to do so could result in electrical shock or personal injury.

•Use Phillips screwdriver to take out the screw.

•Remove the transparent light cover gently.

•Pull out the existing light bulb by unscrewing it counter-clockwise.

•Insert new light bulb (E12, max. 15W) by screwing it in clockwise.

•Replace the transparent light cover and tighten screw.

Automatic Defrost

There is no need for manual defrosting of this wine cooler due to automatic defrosting function.

•The ice build-up on the inner back wall during compressor operation will be automatically defrosted once the compressor cycle is off.

•Defrost water will drain out passing through the drain outlet in the inner back wall into a drain pan located above the compressor, from where it evaporates.

5 EN