Adjusting the Camera
Do Not Adjust
Adjustment Screws
Do Not Adjust
1.With the housing removed, loosen the adjustment screws located near the base of the camera.
2.Adjust the camera to the desired viewing angle.
Marking on Camera
Housing Indicates
Up Position
3.Tighten the adjustment screws to lock camera into place.
Note: Do not over tighten the screws.
4.Reinstall the housing.
Warning
Backing Up Your Vehicle
The product is intended to assist in safe driving and allows the driver to have a broader field of vision during backup. You, as the driver, are solely responsible for the safe operation of your vehi- cle and the safety of your passengers and pedestrians, and abiding all state and local traffic regu- lations. Do not use any features of this system to the extent it distracts you from safe driving. Your first priority while driving should always be the safe operation of your vehicle. Magnadyne will not accept any responsibility whatsoever for accidents and/or injuries resulting from failure to observe these precautions or safety instructions.
Maintenance
Although this Side View Security Camera requires little care, you can still maintain its condition and performance by following these steps:
• Occasionally clean the camera lens with damp soft cloth.
Should you experience any problem with the camera please refer to the troubleshooting guide below prior to returning your camera for repair.
Note: The user should not attempt to service the unit beyond that described in the operating instructions. All other servicing should be referred to qualified personnel.
Troubleshooting
Symptoms | Solutions |
|
|
Cloudy Image | • Clean Dirty Camera Lens |
No Power / Image | • Check Power Connections |
|
|
Upside Down Image | • Check Camera Mounting |
|
|
Unstable Image | • Check Mounting Hardware |
| • Check Power Connections |
3
