Warnings
•The driver should neither watch the display nor operate the system while driving.
Watching the display or operating the system will distract the driver from looking ahead of the vehicle and can cause accidents. Always stop the vehicle in a safe location and use the parking brake before watching the display or operating the system. In some states and countries, pas- sengers are also prohibited from watching the display.
•Never install the product in a location where it interferes with your field of vision.
•This unit has a cooling fan to decrease the internal tem- perature. Do not mount the unit in a place where the cool- ing fan on the unit is blocked. Blocking these openings will inhibit the cooling of the internal temperature and result in damage to the unit.
•Use the proper power supply. This product is designed for operation with a negative grounded 12V DC battery sys- tem. Never operate this product with other battery sys- tems, especially a 24V DC battery system. If the product is used with the improper system it may cause a fire or an accident.
•This product must be installed and used in accordance with this manual. Any alterations to this product that enables it to be used in any way other than intended or designed could distract the driver and result in an acci- dent causing injury or death. Magnadyne Corporation disclaims any and all liability that may result from failure to install and operate in any other manner in which this unit was intended.
•Do not disassemble, modify the unit or attempt to repair the product yourself. If the product needs to be repaired, con- sult your dealer.
•Do not install the unit in a place exposed to direct sunlight or excessive heat or humidity. Avoid places with too much dust or the possibility of water splashing.
•Backing Up Your Vehicle
Do not backup your vehicle while looking at the monitor. Always look in the direction of your vehicle’s motion. Use the monitor only as an aid in safety confirmation. The actual distance may be different than it appears in the mon- itor. The range of the image in the monitor is limited. Always be aware that blind spots may exist and not appear at all times on your monitor.
The product is intended to assist in safe driving and allows the driver to have a broader field of vision dur- ing backup. You, as the driver, are solely responsible for the safe operation of your vehicle and the safety of your passengers and pedestrians, and abiding all state and local traffic regulations. Do not use any features of this system to the extent it distracts you from safe dri- ving. Your first priority while driving should always be the safe operation of your vehicle. Magnadyne will not accept any responsibility whatsoever for accidents and/or injuries resulting from failure to observe these precautions or safety instructions.
Caution |
| Liquid Crystal Panel |
•FCC REGULATIONS STATE THAT ANY UNAUTHO- RIZED CHANGES OR MODIFICATIONS TO THIS EQUIPMENT MAY VOID THE USER’S AUTHORITY TO OPERATE IT.
•TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE.
•THIS DEVICE IS INTENDED FOR CONTINUOUS OPERATION.
•TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK AND ANNOYING INTERFERENCE, USE ONLY THE RECOMMENDED ACCESSORIES.
•Any harsh impacts may damage the liquid crystal panel.
•Usage temperature range: 320F to 1040F. When the tem- perature is very cold or very hot, the image may not appear clearly or may move slowly. Also, movement of the image may seem to be out of synchronization or the image quality may decline in such environments. Note that this is not a malfunction or problem.
•Sudden changes in the temperature inside the vehicle such as those which occur immediately after the vehicle’s air conditioner or heater has been turned on may cause the inside of the liquid crystal panel to cloud over due to water vapor or it may cause condensation (droplets of water) to form and, as a result, the panel may not work properly. Do not use the unit while these symptoms are evident. Instead, leave the unit standing for about an hour, and then resume or start use.
•If the screen of this unit is dirty, wipe the the dirt off with a cloth moistened with a mild cleaner. Note: Applying spray cleaner directly to the unit may affect its mechanical parts or cause an electrical shock. Wiping the screen with an abrasive cloth or using a volatile liquid such as thinner or alcohol may scratch or damage the surface of the screen.
3
