Magnadyne M9860f Radio Display Using the Radio, Listening to the Radio, Display Priority Note

Radio Display

Figure 4

Using the Radio

Listening to the Radio:

1.Turn the vehicle’s ignition key to the “on” or “acc” position to pro- vide power to the radio.

2.Rotate knob (1) clockwise to turn the radio on. Adjust the volume knob (1) to a low listening level.

3.Use the band button (4) to select the AM or FM radio band. The FM band has 3 banks (FM1, 2, and 3). The AM band has 2 banks (AM 1 and AM 2)

4.Use the tuning button (5) to select a desired radio station. Press the

“<“(up) button to tune to higher radios stations.Use the “<“ (down) button to tune to lower radio stations. Pressing and releas- ing the tuning control buttons (5) will cause the tuner to move up or down two decimal increments. Pressing and holding the up or down tuning buttons (5) will cause the tuner to count up or down at high speed.

5.If you are traveling in an area

where you are not familiar with the local radio stations, Press and release the scan button (6). This will activate the auto tuning system and the tuner will scan up to the

next available strong station and stop for 5 seconds. After 5 seconds has passed, the tuner will search up to the next strongest station and stop. If you find a station to your liking, simply press and release the scan button once again to stop the scan operation.

6.Adjust the treble, bass, fader, bal- ance and volume controls as need- ed using the information “Audio adjustments” section of this manual.

Display Priority Note:

The priority of the display area (9) is for the clock. 5 seconds after the last tuning control command, the display will change and display the clock. To recall the radio frequency, press and release the “R.Freq” button (7). The display will change to show the radio frequency then will revert back to the clock after 5 seconds.

8