Magnadyne MRC-2U Learning the Radio’s Remote Code, Group, Seconds Flashes 2 Times

Learning the Radio’s Remote Code

First, see if your radio is in the Manufacturer’s Code Look-Up Table below. If your radio is listed in the table go to “Automatic Code Learning”. If you can not find your radio in the list go to “Manual Code Learning”. Note: This receiver will only retain the one Radio Remote Code.

Manufacturer’s Code Look-Up Table

Manufacturer	Group	Sub-Group	Radio
Alpine,		1	Alpine
	1
JVC,		2	JVC
Pioneer		3	Pioneer
MobileVision,	2	1	MobileVision and MB Quart
MB Quart,
Kenwood		2	Kenwood
Sony	3	1	Sony
		Automatic Code Learning
Step 1			Step 2

Turn on the power to the receiver’s housing.

3 Seconds Flashes 2 Times

Press and hold the button on the receiver for 3 seconds. The LED on the receiver will flash 2 times and then turn off. Release the switch. You are now in “Automatic Code Learning” mode.

Step 3

Flashes the Number

of Times the Switch is

Pressed, Confirming

Group Number

Step 4

Flashes the Number

of Times the Switch is

Pressed, Confirming

Sub-Group Number

Press the switch on/off the number of times accord- ing to the radio manufacturer’s Group number listed in the Manufacturer’s Code Look-Up Table.

The LED will flash the number of times confirming the manufacturer’s group selected.

Press the switch on/off the number of times accord- ing to the radio manufacturer’s Sub-Groupnumber listed in the Manufacturer’s Code Look-Up Table.

The LED will flash the number of times confirming the manufacturer’s sub-group selected.

7