Automatic Code Learning (continued)
Step 5 |
| Step 6 |
or
5 Times
To exit programming push the switch on/off 5 times or wait 15 seconds and the system will automatical- ly exit the “Automatic Code Learning” mode.
Try each button on the remote to make sure each button has been learned properly. If the remote does not function properly proceed to “Manual Code Learning” section below.
Manual Code Learning
Step 1 | Step 2 |
7 Seconds
Flashes 3 Times
Turn on the power to the receiver’s housing.
Press and hold the button on the receiver for 7 seconds. The LED on the receiver will flash 3 times and then turn off. Release the switch. You are now in “Manual Code Learning” mode
Step 3
IR Input
Sensor
Radio Remote
LED on Solid
Within 15 seconds, aim the radio remote at the IR | The LED will light up solid when the code has |
input sensor and push the “VOLUME UP” button | been copied. |
on the radio remote. |
|
8
