Magnavox 13MT1432/17, 13MT1433/17 Cable Box Connections, Helpful Hints, complete the connection

2

Cable Box Connections

If you cable signal uses a cable box or decoder, follow the easy steps below to

complete the connection.

Cable Box (w/RF In/Outputs):

This connection will be mono.

1Connect the Cable Company supplied cable to the signal IN(put) plug on the back of the Cable Box.

2Using a separate round coaxial cable, connect one end to the

OUT(put) (TO TV) plug on the back of the Cable Box.

3Connect the other end of the round coaxial cable to the 75Ω input on the back of the television. Screw it down finger tight.

NOTE: If applicable, set the OUTPUT CHANNEL SWITCH on the back of the cable box to CH 3 or 4. Tune the TV to the same channel and change channels at the cable box. In some cases, the cable box will automatically tune to either channel 3 or 4, change channels until the picture appears.

	Cable Signal IN
	from the Cable
	Company
	2	1	AUDIO IN	SPDIF	IN	VIDEO
						OUT
	CABLE		R	L		S-VIDEO
TO	IN	IR	DVD-D OUT
TV/VCR
			AUDIO OUT	Y	Pb	Pr
		USB	TV			OPTICAL
			PASSCARD			SPDIF

Jack Panel Back of Cable Box

3

75Ω 75Ω

Round 75Ω	Jack Panel Back of TV
Coaxial Cable

Helpful Hints

If no Video Signal is present, the TV will display a “BLUE” screen and shut itself off in about 5 minutes. If the TV is tuned to the AV channel and there is no Video Signal present, the screen will remain black and the TV will shut itself off in about 5 minutes.