Magnavox CC19C1MG, CC13C1MG owner manual ONE Time Program Channel Time on

Timer Recording (cont’d) 33

4

Use the Number buttons (1-8) to select a position in which to store the timer recording. Flashing numbers indi- cate an open position (one in which a timer recording has not been stored yet).

NOTE: If you select a number that already has been used to store a timer recording, PREVIOUSLY SET PROGRAM will appear on the screen for a few seconds. Then information about the program in that position will appear on the screen. If this happens, press the STATUS/EXIT but- ton. Then use the Number buttons to select another position.

5

Use the Number buttons to enter the channel of the TV program you want to record.

●If you are recording from line input, press 0, 0. A/V IN will appear on the screen.

●If you are recording using a Cable Box, enter the Cable Box output channel (03 or 04). Be sure to select the channel of the TV program at the Cable Box and leave the Cable Box on for the timer recording.

ONE TIME PROGRAM

PROGRAM 1

CHANNEL – – –

TO CORRECT PRESS CLEAR

TO END PRESS EXIT

6

Press two Number buttons for the hour(s) you want the recording to begin. Press two Number buttons for the minute(s) you want the recording to begin. Press 1 for AM or 2 for PM. For example, for 9:30 PM, press 09, 30, 2.

ONE TIME PROGRAM

PROGRAM 1

CHANNEL	10
TIME ON	– – : – –

TO CORRECT PRESS CLEAR

TO END PRESS EXIT

7

Follow the instructions in step 6 to set the recording’s stop time. (AM or PM will be set automatically.)

ONE TIME PROGRAM

PROGRAM 1

CHANNEL	10
TIME ON	09:30 PM
TIME OFF	– – : – –

TO CORRECT PRESS CLEAR

TO END PRESS EXIT

Instructions continue on page 34.

4-7

EJECT

POWER

MENU STATUS/EXIT CLEAR

1 2 3

4 5 6

7 8 9

SLEEP/	ALT.CH
WAKE UP
	0
REC	PAUSE
/OTR	/STILL

PLAY

REW F.FWD

STOP

CH.VOL.

MUTE

SPEED

TRACKING MEMORY

Helpful Hints

•If you enter numbers that do not match the TV/VCR’s clock or calen- dar, the entry will be rejected and a question mark will appear on the screen.

•To make corrections while you are programming a timer recording, press the CLEAR button until the cursor is flashing on the item you want to change. Then enter the cor- rect information.