Magnavox CC13C1MG, CC19C1MG owner manual To change the access code, follow these steps

44 SmartLock (cont’d)

To change the access code, follow these steps.

1

Press the MENU button.

6 2,4

> SMARTLOCK		PRESS B
	REVIEW
	EXIT
	PRIM. SETUP
	VCR PROGRAM
	VCR SETUP

2

Press the PLAY/▲ button or the STOP/▼ button to select SMARTLOCK. Then, press the F.FWD/B button.

SMARTLOCK

__ _ _

1

5

3

EJECT

MENU

1

4

7

SLEEP/

WAKE UP

REC

/OTR

POWER

STATUS/EXIT CLEAR

2 3

5 6

8 9

ALT.CH

0

PAUSE

/STILL

PLAY

Enter Your Access Code

3

Use the Number buttons to enter your old access code. The default code is 0711. If you have never set up your personal access code, use 0711 now.

After you enter the code, the SMARTLOCK menu will appear.

SMARTLOCK

X X X-

Enter Your Access Code

4

Press the PLAY/▲ button or the STOP/▼ button to select CHANGE CODE. Then, press the F.FWD/B button.

SMARTLOCK

BLOCK

>CHANGE CODE

SELECT KL CHOOSE B

TO END PRESS EXIT

5

Use the Number buttons to enter your desired access code in the New Code space. Then, enter the same code in the Confirm Code space.

Your new access code should be recorded. You will return to the SMARTLOCK menu.

New Code		_	_ _ _
Confirm Code	_		_ _ _

6

Press the STATUS/EXIT button.

REW F.FWD

STOP

CH.VOL.

MUTE

SPEED

TRACKING MEMORY

Helpful Hints

•To protect the privacy of the access code, an X will appear on the screen instead of the number you enter.

•If a “Wrong Code...” message appears on the screen after you com- plete step 5, you entered the wrong numbers in the Confirm Code space. Repeat the steps on this page.

•You cannot use the default code after you set up your personal access code.

•If a power failure occurs, the default code, 0711, will be the active access code again.

•If you connect the power cord to an AC outlet that is controlled by a wall switch, your personal access code will be erased every time you turn off the power at the wall switch. The default code will be the active code again.