Magnavox MBP5220F owner manual Which does not allow audio to be received by the TV set

Problem

Tip

	No sound or distorted sound.	Adjust the volume.
		Check if speakers are connected correctly.
		Check the HDMI connections.
		Make sure the HDMI cable is not plugged into the HDMI-DVI TV connector
		which does not allow audio to be received by the TV set.
		Check the settings in “Audio Out” menu.
	Picture freezes momentarily during	Check the disc for fingerprints / scratches and clean with a soft cloth wiping
	disc playback.	from center to outer edge.
	Cannot play back a disc.	Make sure that the product supports the disc.
		Check the region code of the disc.This unit supports the following region codes.
		-Blu-ray Disc™ : “A”
		-DVD : “ALL” or “1”
		Clean the disc.
	SD Memory Card cannot be read.	The format of the card is not accepted by this unit or the card is not compatible.
	Cannot play back JPEG files from a disc.	Make sure that the disc was recorded in the UDF, ISO9660 or JOLIET format.
	Cannot play back MP3 files from a	Make sure that the disc was recorded in the UDF, ISO9660 or JOLIET format.
	disc.	Make sure that the bit rate of the MP3 files is between 112 and 320 kbps.
		Make sure that the sample rate of the MP3 files is 32 kHz, 44.1 kHz or 48 kHz.
	Cannot play back WMA files from a disc.	Make sure that the sample rate of the WMA files is 44.1 kHz or 48 kHz.
	No return to start-up screen when	Soft reset this unit by turning it off for 30 seconds, then on again.
	disc is removed.	To completely reset the unit, press and hold [. STANDBY/ON] on the
		front panel for 10 seconds to shut down the unit or unplug the AC cord
		from the AC outlet for 5-10 seconds.
	The unit does not respond to the	Aim the remote control directly at infrared sensor window on the front
	remote control.	panel. (Refer to page 12)
		Reduce the distance to infrared sensor window.
		Check the +/– polarity of the batteries and replace both batteries in the
		remote control if required.
		Go to “IR Signal Check” on page 60.
	in the upper right hand corner	The current operation is not possible.
	of the TV screen.
	Buttons do not work or the unit	To soft reset the unit, press and hold [. STANDBY/ON] on the front
	stops responding.	panel for 10 seconds to shut down the unit or to hard reset the unit by
		unplugging the AC cord from the AC outlet for 5-10 seconds.
	The unit does not respond to some	Operations may not be permitted by the disc. Refer to the instructions for
	operating commands during playback.	the disc.
	The unit cannot read Blu-ray Disc™	Condensation? (Let sit 1 or 2 hours)
	/ DVD/ CD.	Check if the disc is compatible with this unit. (Refer to page 19.)
		Wipe dirt off the disc from the center to the outside or replace the disc.
		Refer to “Cleaning Discs” on page 60.
	Scene shooting angle does not	The angle cannot be switched for Blu-ray Disc™ / DVD which do not contain
	switch.	multiple angles. In some cases multiple angles are only recorded for specific scenes.
	Playback does not start when the	Check the settings in “Parental” menu.
	title is selected.
	The password for rating level has	Enter the default password “4737”, then your forgotten password will be
	been forgotten.	cleared.Then to change password go to “Password Change” on page 49.
EN-54		Continued on next page.