MC09D5MG 4/12/02 12:20 PM Page 6

6 Hooking Up the TV/VCR

1 Hook up your TV/VCR using one of the connections shown.

Connect a Cable signal or an antenna to the ANT(enna) Jack.

AHooking Up Your TV/VCR With a

Cable Signal or Outdoor Antenna

ANT

B Hooking Up Your TV/VCR With a Cable Box

To view any channel, set the TV/VCR to the Cable Box output channel (channel 03 or 04). Then, select channels at the Cable Box.

Connect an RF coaxial cable (75- ohm, not supplied) to the OUT Jack on the Cable Box and to the ANT(enna) Jack on the TV/VCR.

CHooking Up Your TV/VCR With the Supplied Rod Antenna

To install the supplied rod antenna, push the stem of the antenna into the antenna hole on the back of the TV/VCR. Connect the antenna wire to the ANT(enna) Jack on the back of the TV/VCR as shown. Extend the antenna and adjust its length, direction, and angle for the clearest picture.

Connect the Cable signal to the IN Jack on the Cable Box.

OUTIN

RF coaxial cable

(not supplied)

ANT

Rod Antenna

(supplied)

ANT

2 Connect the AC power cord to the AC 120V jack on the back of the TV/VCR. Plug the AC power cord into an AC power outlet. Use only the supplied AC power cord.

3 Before you turn on the TV/VCR, go to page eight.

Helpful Hint

Before connecting an antenna or cable signal to the ANT(enna) Jack, make sure the pin is not bent. If the pin is bent, straighten it as illustrated, then connect the antenna or cable signal to the ANT(enna) Jack.

Crooked Pin

Plug

Straight Pin

Bent pin

Cable

 

 

Page 6
Image 6
Magnavox MC09D5MG owner manual Hooking Up the TV/VCR, Hook up your TV/VCR using one of the connections shown