First-time DVD/VCR Setup 17

Before turning on your DVD/VCR, make sure batteries are in the remote control and the DVD/VCR and TV are connected correctly. You cannot program channels if you are using a Cable Box or a Satellite Receiver.

These menus may not appear if you have already turned on the DVD/VCR.

1 Turn on the TV. Set it to channel 3 or 4 or its AUDIO/VIDEO IN channel, depending on how you con- nected the DVD/VCR to a TV.

2 Press STANDBY-ON.The green VCR light and the red

STANDBY-ON light will appear on the front of the DVD/VCR. The display shown below will appear.

These menus may not appear if you have already turned on the DVD/VCR. You may have turned on the DVD/VCR before to find the Audio/Video In channel of the TV, for example. If so, follow the steps on page 26 to set up chan- nels and page 30 to select a language for the VCR menus.

3 Press o or p to select English, French, or Spanish as the language for VCR on-screen displays and menus. Then, press B.

1 Turn on the TV.

 

 

STANDBY-ON

2

TIMER SET

 

 

SETUP

AUDIO SUBTITLE

ANGLE

REC

REPEAT

REPEAT

 

 

 

A-B

 

 

C-RESET

 

 

SKIP/

CLEAR

SKIP/

 

CH

CH

 

 

 

TITLE

MODE

RETURN

 

 

DISPLAY

 

 

DVD

 

VCR

 

DISC

 

 

 

MENU

 

OK

 

3-4

STOP

PLAY

REW

FF

 

PAUSE

SPEED

1 2 3

SLOW

4 5 6

VCR/TV

7 8 9

ZOOM SEARCH MODE

+10 0

AUTO SET UP

4 Press B to begin channel programming. AUTO SETUP will flash on the TV screen during the channel search. The DVD/VCR will memorize all available channels. When channel programming is complete, the lowest avail- able channel will appear on the TV.

These channels will be available when you want to watch TV while in VCR mode. To put the DVD/VCR in VCR mode, press VCR so the green VCR light appears. Use the SKIP i/CHo and SKIP j/CHp buttons to select memorized channels. To select non-memorized channels, use the Number buttons.

Helpful Hints

To skip this feature and play a tape immediately, insert a tape with its record tab removed.

To skip step 3, press DISC/MENU. VCR menus and displays will be in English.

If you try to program channels when there is no antenna or Cable TV signal connected to the ANT-IN jack of the DVD/VCR, programming will stop. AUTO SET UP will stop flashing. Connect an antenna or Cable TV signal to the DVD/VCR’s ANT-IN jack and press B again.

Repeat this process if the power fails.

To stop the Channel Setup while AUTO SET UP is flashing, press

DISC MENU.

Page 17
Image 17
Magnavox MDV 530 VR owner manual First-time DVD/VCR Setup, Turn on the TV, Repeat this process if the power fails