75
ANT /
CABLE
COAXIAL
S-VIDEO
OUT DIGITAL
AUDIO OUT
AUDIO
OUT
COMPONENT
VIDEO OUT
L
Y
R
CB
CR
DVD
AUDIO OUT
VIDEO OUT
AUDIO IN
VIDEO IN
L
R
L
R
DVD/VCRVCR
ANT-IN
ANT-OUT
AUDIO OUT
VIDEO OUT
AUDIO IN
VIDEO IN
L
R
L
R
DVD/VCR VCR
ANT-IN
ANT-OUT
75
ANT /
CABLE
Black RF
coaxial cable
(supplied)
Antenna or
Cable TV
signal
1Disconnect the antenna or Cable TV signal from your TV and con-
nect it to the ANT-IN (Antenna In) Jack of your DVD/VCR.
2Connect the supplied black RF coaxial cable to the ANT-OUT
(Antenna Out) Jack on the back of the DVD/VCR and to the
ANTENNA IN Jack on the TV. The ANTENNAIN jack on the TV may be
labelled TV IN, RF IN, 75(ohm), or ANT. IN. See your TV owners manual
for assistance.
3Plug in the power cords of the TV and the DVD/VCR.
4Set your TV to channel 3 or 4. The DVD/VCRs output channel is 3 when
you purchase it. So, set your TV to channel 3 when the DVD/VCR is new.
If you cannot use channel 3 at your TV, you can change the DVD/VCRs out-
put channel to channel 4. To do so, press the VCR button to put the
DVD/VCR in VCR mode. The green VCR light will be on the front of the
DVD/VCR. Insert a videotape and press PLAY Bto start playback.
During playback, press and hold the (VCR) PLAY Bbutton on the
front of the DVD/VCR for three to five seconds. Each time you do this,
the DVD/VCRs output channel switches between 3 and 4. Change your TV to
channel 3 or 4 accordingly. (You cannot change the DVD/VCRs output chan-
nel while adjusting tracking manually. Press STOP Cto stop play and cancel
manual tracking, then press PLAY Bto resume play and change the output
channel.)
There is not a channel 3/4 switch on the DVD/VCR (as customary with most
VCRs).
5You are ready to turn on the DVD/VCR. Go to page 17 before turn-
ing on the DVD/VCR.
Antenna In Jack
(on back of TV)
example only
8 Hookups (contd)

DVD/VCR to TV only

Simplest connection using only the supplied black RF coaxial cable

This connection will let you use the features of both the VCR and the DVD Player.

1
2