JAI TS-1327EN, TS-9720EN, TS-2030EN X15 Lane Controller, Arrow down negative going, Test Trigger

VIS-CAM System

Arrow down – negative going

As a guideline the two LEDs marked TRIG-0 and TRIG-1 shall be off when no trigger pulse is present.

3.3.5 (b) Test Trigger

Activating switches S1 and S4 generates a trigger pulse for test purposes. Only one trigger pulse is generated each time the switch is activated.

The duration of the trigger pulse is approximately 4 ms.

The trigger indicator LEDs flash when the test trigger switch is activated.

Figure 24. Test trigger

3.3.6X15 Lane Controller Connector (X4 and X5)

The Lane Controller connection to the J-Panel is connector X15. The connections are listed in Table 8 .

Table 8		X15 Lane Controller
	X15 Pin #	Signal	Description	Connection to
	1	D0+	RS485 databus D0+	Lane Controller databus 0+
	2	D0-	RS485 databus D0-	Lane Controller databus 0-
	3	Gnd	gnd	gnd
	4	D1+	RS485 databus D1+	Lane Controller databus 1+
	5	D1-	RS485 databus D1-	Lane Controller databus 1-

It is possible to have one Lane Controller connected to several cameras or one Lane Controller to each camera:

One Lane Controller for two or more cameras

1.The Lane Controller is connected to the X15 pin 1 and 2 (no connections to pin 4 and 5)

2.Switch S2 position “OPEN”

3.The Lane Controller can be connected to more J-Panels by connecting RJ45 patch cables between connector X4 and connector X5 on the next J-Panel (and from X4 on the next J-Panel to X5 on the third J-Panel). Switch S2 on the other J-Panels must also be in the “OPEN” position.

Two Lane Controller to two cameras

1.The Lane Controller for camera 0 is connected to X15 pin 1 and 2

2.The Lane Controller for camera 1 is connected to X15 pin 4 and 5

3.Switch S2 position “TERM”

4.Do not connect any cables to X4 and X5

28 Installing the Vehicle Imaging Subsystem