VIS-CAM System
5.3.9(a) Connector physical Interface
Table 15 Physical interface pinouts.
Pin | Signal | Description | Connection to |
|
|
|
|
1 | Gnd | Light/Flash Gnd | Light/Flash ground (negative power terminal) |
|
|
|
|
2 | Out | Light control/Strobe out | Light control input or strobe input on flash unit |
|
|
|
|
3 | Stat | Light/Strobe status | Light/Flash Status output from unit |
|
|
|
|
4 | FPWR | Light/Flash power | Power from Light/Flash unit to output circuit on I/O Board |
|
|
|
|
The Gnd signal on pin 1 is connected to the Gnd signal on X5 (pin 2) internally on the board.
5.3.10 Typical Wiring Diagram
Figure 52 shows how to connect to the 2nd DC Flash unit having the I/O Board electronics powered from the Flash Power Supply.
Figure 52. Wiring a second DC flash from the flash power supply.
Appendix A: Camera Functional & Connector Description | 55 |
