JAI TS-1327EN, TS-9720EN, TS-2030EN manual Optimal Illumination Distance Between Camera and TNF

VIS-CAM System

•Press the “Repetitive Trigger” button on the ENSetup toolbar. This will trigger the camera every second. Make sure that the “Ethernet” external hardware trigger is enabled in the “Camera Properties” section “2 – Trigger”, property “External Trigger Source”.

•Adjust the flash head tilt and pan control until the entire back of the vehicle is well illuminated. If necessary, adjust the flash-head pan control to center the flash beam over the vehicle.

•If the flash illumination is too bright for your installation, contact JAI for instructions on how to adapt VIS system parameters to reduce sensitivity to nighttime illumination.

Repeat pressing the “Repetitive Trigger” button on the ENSetup toolbar to stop flash firing. Repeat the above steps for each camera/flash.

Table 13 Optimal Illumination Distance Between Camera and TNF

Distance in Feet

TS-9720EN TSC-9720EN TS-2030EN TSC-2030EN TS-2076EN TSC-2076EN TS-1327EN TSC-1327EN
3.5	TBD	2	1	TBD	TBD	TBD	TBD

Distance measured from outer wall of Camera housing to outer wall of Flash unit.

System Set-Up 43