JAI TS-9720EN, TS-1327EN, TS-2030EN Signal parameters and conditions, Trigger output Description

VIS-CAM System

6.2.1Functionality

Power and data connection to the EN camera. The 24V power supply for all camera functions (Camera, I/O Board, light and heaters), Ethernet and RS485 data communication is connected by means of this connector.

6.2.2Connector specification

Connector type:	16 pole WAGO pluggable terminal block
Connector on board:	WAGO 734-246
Cable part:	WAGO 734-216

6.2.3Connector signal specifications

6.2.3 (a) Lane Controller interface Description

RS485 two wire half-duplex multi-drop communication network. The I/O Board has connections for daisy chain configuration. The two signal pairs (RS485D+ and RS485D-) can be reversed.

Signal levels:

Standard RS485 communication levels. Electrical interface on the J-Panel: The signals are connected to J-Panel X15 pin 1 and 2. There are termination resistors on the board. See Figure 49 on page 53 for a description of the signal path.

6.2.3(b) Trigger output Description

The trigger output is balanced and the driver is a RS485 transmitter (LTC1480).

Signal levels

The signal levels are at standard RS485 levels. The specification below is taken from Linear Technologies datasheet for LTC1480:

Table 17 Signal parameters and conditions.

Electrical interface on the J-Panel:

Figure 65. J-Panel electrical interface

66 Appendix B: J-Panel Functional & Connector Description