Disconnect the antenna or cable from your TV | Magnavox VR401BMG

6 Hookups Without a Cable Box/Direct Broadcast System

The basic VCR/TV connection – antenna/cable to VCR to TV – is shown below. If you have a Cable Box or a Direct Broadcast System, please see pages eight-nine. If you have a Stereo TV, please see page 10. After you hook up the VCR, go to page 11 to turn on the VCR. (The VR601BMG is illustrated here. The VR401BMG has single AUDIO IN/OUT jacks.)

1

Disconnect the antenna or cable from your TV.

Antenna

Indoor/Outdoor

(300 ohm)

75 ANT / CABLE

75V

ANT /

CABLE

OR

ANTENNA IN

Jack

(on back of TV)

Cable

(75 ohm)

2

Connect the antenna or cable to the ANT(enna) IN Jack of your VCR.

Antenna

Indoor/Outdoor

(300 ohm)

OR

Cable

(75 ohm)

Back of VCR

			AUDIO		ANT
			L		IN
			OUT	IN
			R
		ANT	VIDEO		OUT
					OUT
			OUT	IN	CH3 CH4
AUDIO
AUDIO		IN
	L	IN
	L
OUT	IN
	R
VIDEO		OUT
VIDEO
OUT	IN CH3	CH4

Image 6

Magnavox VR401BMG Hookups Without a Cable Box/Direct Broadcast System, Disconnect the antenna or cable from your TV

Contents

VCR Warranty Verification For Customer Use Introduction FeaturesSafety Precautions Declaration of Conformity Table of Contents VCR maintenance Before Using Your VCRPutting Batteries in the Remote Control Replace the battery compartment lid Hookups Without a Cable Box/Direct Broadcast System Disconnect the antenna or cable from your TV Hookups Without a Cable Box/Direct Broadcast System cont’d Plug in the TV and the VCR Hookups With a Cable Box/Direct Broadcast System ConnectionsRecording/Viewing Any Channel Cable Signal Cable Box/DBS Recording One Channel/Watching AnotherTV’s Antenna Hookups with a Stereo TV VR601BMG Turning on Your VCR 2Turn on the TVPress the Menu button. The display shown below will appear Automatic Channel Setup Press the Menu buttonVR601BMG only Automatic Channel Setup cont’d Adding/Deleting Channels Reviewing Memorized Channels Press the STATUS/EXIT button once or twice to exit Follow the steps below to set your VCR’s clock. Make sure You make each entry within 60 seconds of the previous entry Daylight-Savings Time Language Selection Remote Control Buttons Remote Control Buttons cont’d Clear ButtonChannel o/p Buttons If you select Status ON, then select Counter only on On-Screen Status DisplaysStatus Display example only If you select Status ON, then select Counter only OFF VCR Display Panel Front Panel Rear Panel Playing VHS Quasi Play Back SqpbRead and follow the steps below to play a tape RECord light will appear RecordingInsert a tape with its record tab intact in the VCR 1Turn on the TV 2Insert a tape in the VCR Recording One Channel/Watching Another One-Touch Recording Timer Recording Do each step within 60 seconds of the previous stepDaily Timer Recording cont’d Instructions continue on Tape Speeds Checking or Cancelling Timer Recordings Rerecording Tape Duplication RF coaxial cable Repeat Play Press the PLAY/o button or the STOP/p button to selectPress the F.FWD/B button so that on appears beside Real-Time Counter Memory Time Search Press the Time Search button Super High Speed Searching LP/SLP Special Effects PlaybackForward and Reverse Searching SP/LP/SLP Viewing a Still Picture Automatic Operation Features Understanding On-Screen Displays Specifically…Monitor Multi-Channel Television Sound System VR601BMG only cont’d Hi-Fi Stereo Sound System VR601BMG only Please see additional notes on Blue Background Helpful Hints Helpful Hints cont’d Glossary Cable Box/DBS Output Channel 03 or Specifications Limited Warranty Timer PowerRemote control Audio in/out jacks Supplied Accessories