Makita 1051D instruction manual Edge fence Guiderule, Blade height adjustment

Edge fence (Guiderule)

Use the edge fence when shiplapping (rab- beting) or cutting workpieces nearly 50 mm (1-31/32")wide. Install the edge fence on the tool and secure it with the washer and thumb screw (A)..Loosen the thumb screw

(B)and adjust the edge fence until it comes in contact with the side of the workpiece. Then tighten the thumb screw (B) securely.

Blade height adjustment

Blade height adjustment is usually not nec- essary. However, if you notice that the blade edge is below the level of the rear base or protrudes too far from the rear base, proceed as follows.

Loosen the two installationbolts. Turn the pan head screws clockwise to retract the blade or counterclockwise to protrude it.

After adjusting the blade height, tighten the two installation bolts securely.

- c ------	/--		(e)
E----		Thumb screw
Edge fence -I
/		I

Pan headscrews ,-

Installation bolts

II

12