Shiplapping (Rabbeting)
To make a stepped cut as shown in Fig., use the edge fence (guide rule).
Draw a cutting line on the workpiece. Align the blade edge with the cutting line.
Then adjust the edge fence as explained in the "Edge fence" section. When planing, move the tool with the edge fence flush with the side of the workpiece. Otherwise uneven planing may result. Max. shiplap- ping (rabbeting) depth is 15 mm (9/16").
CAUTION:
Before shiplapping, make sure that the blade end protrudes slightly from the side
of the drum. | Blade edge 'ILSide of drum |
Chamfering
To make a cut as shown in Fig., align the "V" groove in the front base with the edge of the workpiece and plane it as shown in Fig. It chamfers up to 5.6 mm (7/32")in a single pass.
5.6mm(7/32)
5Emm
(7/32')
I
groove
II | I |
| Front base |
13
