Adjusting depth of cut
The depth of cut can be adjusted in 0.1 mm increments within (0.02"). Turn the knob on the front of the tool until the pointer is cutting depth on the scale.
a range of 0 - 0.5 mm aligned with the desired
Scale 1 Pointer
CAUTION:
The knob can be turned beyond the 0.5 mm (0.02")graduation. However, do not operate the tool with a depth of cut more than 0.5 mm (0.02"). The motor may be burned out or the battery cartridge may be damaged.
Switch action
CAUTION:
Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released.
To prevent the switch trigger from being accidentally pulled, a
11
