Lock the drum in the position whereby the blade edge faces upward. Place the triangular rule flat on the outfeed table. Turn the adjusting screws until the blade edge just contacts the triangular rule. After adjusting both adjusting screws, pull the lock pin to unlock the drum. Rotate the drum by turning the knob clockwise to make sure the blade protrusion is a t exactly the same height all the way across. If not, adjust the adjusting screws again.
After carefully adjusting the blade pro- trusion, lock the drum in the position whereby the blade installation bolts face upward. Securely tighten the blade installation bolts evenly from the center of the outside.
Then slightly retighten the adjusting screws by turning clockwise.
Outfeed table
I
17
