Makita 2030S instruction manual Operation

Operation

Determine the depth of cut as described before. Insert the workpiece flat on the table top. When cutting a long or heavy workpiece, lift up i t s end slightly at the start and the end of the cut to avoid goug- ing or sniping a t the extreme ends of the work piece.

Two rollers are provided on top of the tool to enable quick, effotless return of the workpiece to the infeed table side. This is especially convenient with two operators.

Roller

CAUTION :

e Workpieces with the following dimensions cannot be fed into the auto-planer because the interval between the two feed rollers is 114 mm (4-1/2").Do not try to cut them.

1 1	Fq	I1 Less than I 1 5 mm (4-1/ 2 " ) long.
I	Less than 1 1 5m m

I

7-

More than 1 1 5 mm (4-1i2") II

Having a groove more than 115 mm (4-1/2")wide.

	115mm(4112 I
3	Having grooves at intervals of 1 1 5 mm (4-1/2").

estop the tool when the workpiece has stalled. Allowing the tool to run with a stalled workpiece causes rapid wearing of the feed rollers.

8