Makita 2030S instruction manual For Jointer

FOR JOINTER

1.Maintain the proper relationships of infeed and outfeed table surfaces and cutterhead blade path.

2. Do not perform jointing operations on material shorter than 140 m m (5-1/2 inches), narrower than 19 m m ( 3 / 4 inch), or less than 12.7 m m (112 inch) thick.

3.Do not perform planing operations on material shorter than 140 m m (5 - 1/2 inches), narrower than 19 m m ( 3 / 4 inch), wider than 155 m m (6-1/8inches) or thinner than 12.7 m m (112 inch).

4.Support the workpiece adequately at all times during operation; maintain control of the work at all times.

5. Do not back the work toward the infeed table.

6.Do not attempt t o perform an abnormal or little-used operation without study and the use of adequate hold-down/push blocks, jigs, fixtures, stops and the like.

FOR AUTO-PLANER

1.Two or more pieces of narrow but similar thickness stock can be passed through the auto-planer side by side.

However, allow some spacing between the stock t o permit the feed rollers to grip the thinnest piece.

Otherwise, a slightly thinner piece could be kicked back by the cutterhead.

2.Determine the depth of cut according t o the table shown on the front of the tool. Do not attempt t o cut more than the specified amount in one pass.

WARNING

For Your O w n Safety, Read Instruction Manual Before Operating Jointer

1.Wear eye protection.

2.Never perform jointing or planing operation with cutter head or drive guard removed.

3.Never make jointing or planing cut deeper than 3 m m (118 inch).

4.Always use hold-down/push blocks for jointing material narrower than 76 . 2 m m (3inches), or planing material thinner than 76 . 2 m m (3inches).

SAVE THESE INSTRUCTIONS.

5