001145

1

1. Limit mark

001716

1

2

1.Screwdriver

2.Brush holder cap

Replacing carbon brushes

Remove and check the carbon brushes regularly. Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same time. Use only iden- tical carbon brushes.

Use a screwdriver to remove the brush holder caps. Take out the worn carbon brushes, insert the new ones and secure the brush holder caps.

To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts.

ACCESSORIES

CAUTION:

These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.

If you need any assistance for more details regarding these accessories, ask your local Makita service center.

1/4” router bits

Straight & groove forming bits

Edge forming bits

Laminate trimming bits

Straight guide assembly

Trimmer guide assembly

Trimmer base assembly (For chamfering with straight bit)

Trimmer shoe

Templet guide

Collet cone 1/4”

Wrench 10

Wrench 17

13

Page 13
Image 13
Makita 3707FC instruction manual Accessories, Replacing carbon brushes