9.Before using the tool on an actual work- piece, let it run for a while. Watch for vibration or wobbling that could indicate improperly installed bit.
10.Be careful of the bit rotating direction and the feed direction.
11.Do not leave the tool running. Operate the tool only when
12.Always switch off and wait for the bit to come to a complete stop before removing the tool from workpiece.
13.Do not touch the bit immediately after operation; it may be extremely hot and could burn your skin.
14.Always lead the power supply cord away from the tool towards the rear.
15.Do not smear the tool base carelessly with thinner, gasoline, oil or the like. They may cause cracks in the tool base.
16.Draw attention to the need to use cutters of the correct shank diameter and suitable for the speed of the tool.
17.Some material contains chemicals which may be toxic. Take caution to prevent working dust inhalation and skin contact. Follow material supplier safety data.
SAVE THESE INSTRUCTIONS
WARNING:
MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury.
SYMBOLS |
The followings show the symbols used for tool.
V | volts | n˚ | no load speed |
.................... | |||
A | amperes | .................... | Class II Construction |
Hz | hertz | .../min | revolutions or reciprocation per |
| alternating current |
| minute |
................ |
|
|
5
