Adjusting for accuracy of 90° cut (vertical cut)

This adjustment has been made at the factory. But if it is off, adjust the adjusting screw with a hex wrench while squaring the blade with the base using a triangular rule, try square, etc.

CAUTION:

Do not touch or tamper two securing screw.

1. Adjusting screw for 90

1

007403

1. Triangular rule

1

007404

Replacing carbon brushes

1. Limit mark

1

001145

Remove and check the carbon brushes regularly. Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same time. Use only identical carbon brushes.

Use a screwdriver to remove the brush holder caps. Take out the worn carbon brushes, insert the new ones and secure the brush holder caps.

2

 

1.

Brush holder

 

 

 

cap

 

1

2.

Screwdriver

 

 

 

 

 

 

 

001521

To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts.

OPTIONAL ACCESSORIES

CAUTION:

These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.

If you need any assistance for more details regarding these accessories, ask your local Makita Service Center.

Steel & Carbide-tipped saw blades

Combination

General purpose blade for fast and smooth rip,

crosscuts and miters.

 

 

 

Pressure treated/

Designed for fast cutting of pressure treated and

Wet lumber

wet lumber.

 

 

006545

Rip fence (Guide rule)

Hex wrench

NOTE:

Some items in the list may be included in the tool package as standard accessories. They may differ from country to country.

10

Page 10
Image 10
Makita 5377MG-R Optional Accessories, Adjusting for accuracy of 90 cut vertical cut, Replacing carbon brushes